Sensors for extreme requirements

Application example

Sensors for mobile use

Applications
The new efectorm units of the mobile series are specially adapted for use in vehicles. The sensor is designed so that it meets the highest demands. standhält.

e1 type approval
The e1 type approval by the Kraftfahrt-Bundesamt certifies that the units comply with the automotive standards and may therefore be mounted on vehicles without invalidating the vehicles' operating permit. erlischt.

Environmental influences
For the design special attention was given to the resistibility to the most important environmental influences. The units pass environmental tests without problem, for example salt spray test, temperature/humidity cycles, continuous shocks and vibration.

Wide temperature range
The permissible application range of the sensors covers -40 °C to +85 °C. Furthermore, the units are insensitive to rapid temperature changes.

High ingress resistance
The sensors of the mobile efectorm series are distinguished by their superb seal and withstand even high-pressure cleaning without problem. This is evidenced by the protection rating IP 69 K.

Inductive M18 proximity switches - efector m series - Product examples
	IGM200 - nominal sensing range 8 mm flush, 10...36 DC
	IGM201 - nominal sensing range 12 mm non flush, 10...36 DC
Inductive M30 proximity switches - efector m series - Product examples
	IIM200 - nominal sensing range 12 mm flush, 10...36 DC
	IIM201 - nominal sensing range 22 mm non flush, 10...36 DC

Flexible pressure switches for use in mobile hydraulic applications

Applications
In mobile hydraulic applications abruptly switching valves can lead to pressure spikes which are much higher than the operating pressure. In particular load monitoring requires the highest reliability. Quick and precise response of the sensor is as indispensable for the protection of the aggregate as clear and easy setting of the sensor.

The sensor
The highly resistant measuring cell is resistant to extreme operating conditions. The electronics allow quick and precise conversion of the sensor signal into switch points. Precise and easy switch point setting is possible even without system pressure. Programming from normally closed to normally open is possible at any time. Damping and delay times are freely selectable by the user.

Programming
Das optional verfügbare The optional programming unit turns a simple pressure switch into an intelligent sensor. The parameters set can be transferred to any number of pressure switches using a programming unit. Set-up by the temporarily connected programming module is very simple. In short: The right sensor for every application!

Product examples

	PP7540 - 0...400 bar
	PP7542 - 0...100 bar
	PP7543 - 0...25 bar
	PP7544 - 0...10 bar
	PP2000 - programming unit